Jig Setup for a

Right-Tilt Table Saw

In this procedure you will assemble the tenoning jig. The guide bar is initially in position on the jig for jig use on a right-tilting table saw. If you need to use the jig on a left-tilting table saw, go to Jig Setup for a Left-Tilt Table Saw on Page 10.

To set up the jig for a right tilt table saw:

1.Attach the clamp arm to the work support plate with the cap screws and lock washers as shown in Figure 2.

Note: The cap screws are different lengths and must go into the correct holes. See Figure 2 for the long (M10-1.5 x 25mm), and short cap screw (M10-1.5 x 20mm) hole loca- tions.

Work Support Plate

 

 

Clamp Arm

Short Cap Screw

Long Cap Screw

Figure 2. Partial assembly.

2.Install both handles into the jig as shown in Figure 2.

3.Slide the handwheel onto the end of the clamp assembly threaded shaft and secure it with the setscrew in the handwheel hub.

4.Attach the clamp assembly to the clamp arm with an M8-1.25 x 50 cap screw and the 8mm fender washer (see Figure 3).

Clamp

Assembly

M8-1.25 x 50 Cap Screw

and Oversized Washer

Figure 3. Completed assembly.

5.Insert the jig guide bar into the miter slot in the table-saw table (Figure 4), and perform Guide Bar Adjustment on Page 11.

Guide Bar

Inserted

Into the

Miter Slot

Figure 4. Installed jig.

H7583 Tenoning Jig

-9-

Page 11
Image 11
Grizzly H7583 instruction manual Jig Setup for a Right-Tilt Table Saw, To set up the jig for a right tilt table saw