Compressed Air

System

The Model H7826 is designed to be oper- ated at 70-110 PSI using clean, dry, regu- lated, compressed air. DO NOT exceed the 120 PSI maximum operating pres- sure for your model. Before using, regu- late the air pressure on your air compres- sor to 70 psi.

An in-line filter/lubricator/regulator unit, depicted in Figure 2, can be installed and should be located as close to the nailer as possible.

The filter/lubricator/regulator unit will pro- tect your tool from damaging water build- up, allow you to adjust and maintain constant air pressure to your tool, and save you the inconvenience of having to manually lubricate your tool every time you use it.

Exceeding the maximum permissible operating pressure may cause the nailer to explode, blowing metal frag- ments in all directions. To protect yourself from serious personal injury, DO NOT allow your air compressor to exceed the recommended pressure when connected to this nailer!

Quick

Quick

Lubricator

Connector

Connector

Regulator

Your

 

 

Air

Tool

 

 

Compressor

Quick

 

 

 

Coupler

 

Quick

 

 

Air Hose

Filter

 

Coupler

 

 

Figure 2. Typical filter/lubricator/regulator installation order.

Check the current Grizzly catalog for avail- ability of this unit. If you plan on install- ing a filter/lubricator/regulator unit in your compressed air system, always follow the connection instructions that come with the unit.

Model H7826 Flooring Nailer

-7-

Page 9
Image 9
Grizzly H7826 owner manual Compressed Air System