Grizzly H7826 owner manual Operations, Oiling Nailer Loading Nailer, To load your nailer

SECTION 3: OPERATIONS

Oiling Nailer Loading Nailer

Pneumatic oil has been included with this Grizzly nailer to help maintain its useful life. Place several drops of oil in the nailer air inlet (as shown in Figure 3) before every use and several times a day if used continuously. Wipe off any excess oil near the nailer exhaust to avoid dust build-up. When the oil that was included with the nailer has been completely used, replace with Grizzly Model G2820 Pneumatic Tool Oil.

Figure 3. Lubricating nailer via air inlet.

Another option to manual oiling would be to install a lubricator, or a filter/lubricator/ regulator unit, in your air compressor line. If your air compressor line already has a lubricator, then regular lubrication of your nailer will not be necessary. Just make sure there is always pneumatic tool oil in the lubricator.

When replacing nails in your Model H7826, follow these guidelines:

Nails:	L-shaped cleat nails
Length:	11⁄2"–2"

Capacity: 100

Note: Use 11⁄2" nails to install 1⁄2" flooring. Use 2" nails to install 3⁄4" flooring.

To load your nailer:

1.DISCONNECT NAILER FROM THE AIR SUPPLY!

2.Slide a strip of nails, pointed-end down, into the magazine as shown in Figure 4.

Figure 4. Loading nails into nailer.

3.Push the button inside the pusher (inset photo in Figure 4), pull the pusher all the way back, then allow the pusher to slide forward against the nail strip.

Model H7826 Flooring Nailer -9-