Black Box ET0010A, ET1000A manual Status Indicators, Rear Panel, Indicator Light State Indication

ETEP Introduction

Status Indicators

The ET0010A status indictors are shown in Figure 3. The status indications are described in Table 1.

Figure 3 ET0010A Status Indicators

Elements of Figure 3:

1)Power LED

2)Alarm LED

3)Status indicators

4)Link indicators

The following table describes how to interpret the ET0010A status indicators.

Table 1 ET0010A Status Indicators

Indicator Light	State	Indication
Power (green)	Off	Unit is powered off.
	On	Unit is powered on.
10/100 link status	Off	Loss of signal on the 10/100 link.
(green)a
	On	The 10/100 link is up but no traffic is passing over the link.
	Blinking	Indicates the presence of traffic on the 10/100 link.
Gigabit link status	Off	Loss of signal on the Gigabit link.
(amber)a
	On	The Gigabit link is up but no traffic is passing over the link.
	Blinking	Indicates the presence of traffic on the Gigabit link.
Alarm (green)	Off	Normal operation.
	On	The unit is in an error state. This occurs when the
		diagnostics detect a boot failure, a critical error threshold is
		exceeded, or a FIPS test fails when the ETEP is in FIPS
		mode.
Status (1,2,3,4)	Off	Unit is up and operational.
	On	Displays diagnostic codes during boot up.

a. The link status LEDs are on the remote and local data ports, Ethernet management port, and Aux1 port.

Rear Panel

The ET0010A rear panel and external power supply are shown in Figure 4.

ETEP Installation Guide 11