Black Box ET0100A, ET1000A, ET0010A manual Installation, Safety Guidelines, Software Requirements

2 Installation

Safety Guidelines

The ETEP does not contain any field-replaceable internal parts. Do not remove the unit’s cover for any reason. The cover is to be removed only by authorized Black Box service personnel.

Authorized service personnel should review the following safety information prior to performing service or maintenance procedures on the ETEP.

CAUTION

Disconnect all power cords before servicing.

WARNING

The ETEP contains a lithium battery, which users should not attempt to replace. Battery replacement must be performed by qualified Black Box personnel. Risk of explosion if battery is replaced by an incorrect type. Used batteries should be disposed of according to the manufacturer’s instructions.

CAUTION

Electrostatic discharge (ESD) can damage electronic components and equipment. ESD occurs when electronic components are improperly handled and can result in complete or intermittent failures. Always follow ESD-prevention procedures when removing and replacing components.

Qualified service personnel should use the following guidelines to prevent ESD damage:

•

•

•

Always use an ESD wrist or ankle strap and ensure that it makes skin contact. Connect the equipment end of the strap to an unpainted metal chassis surface. If no wrist strap is available, ground yourself by touching the metal chassis.

Software Requirements

ETEP software is factory installed on the appliance. A backup copy of the software is provided on the ETEP CD. To learn how to reinstall your software or install an update, refer to the user guide for your management software.

ETEP Installation Guide 27