Black Box ET1000A, ET0100A manual Cable Pinouts, RS-232 Serial Cable ET0010A and ET10000A

Maintenance

To recover the ETEP following zeroization:

Wait approximately 20 minutes for the zeroization process to complete. If you are connected to the ETEP through the serial port, you will see the following message:

Power cycle required to reboot appliance

After cycling the power, you will be able to configure and manage the ETEP from its factory default settings. If you cycle the power prior to the completion of the zeroization process the appliance will enter an unrecoverable state, which requires returning the ETEP to the factory.

Cable Pinouts

This section lists the serial cable pinouts for the following ETEPs:

•

•

ET0010A and ET10000A ET0100A and ET1000A

RS-232 Serial Cable: ET0010A and ET10000A

The RS-232 serial cable on the ET0010A and ET10000A is a null modem cable with an RJ-45 connector to the ET0010A and a DB-9 female connector to a PC or laptop.

Figure 50 ET0010A Null Modem Serial Cable

Table 24 ET0010A Null Modem Pin Connection

RJ-45 Pin		DB-9 Pin
3	Receive Data	3	Transmit Data
6	Transmit Data	2	Receive Data
5	Signal Ground	5	Signal Ground

70 ETEP Installation Guide