Installation
Rack Mount Installation
To mount the ETEP in a standard
•
•
•
•
External power supply
Two mounting brackets, supplied in the Accessory Kit
(4)small black screws and (4) large
To install the ETEP in a rack:
1Place the unit on a solid surface, with the bottom panel facing up.
When looking at the ET0010A from the bottom rear, the bracket that holds the power supply is on the right, as shown in Figure 14.
On the ET0010A, the bracket that holds the power supply is on the left.
Figure 14 Bottom rear view of the ET0010A, with rack mount brackets
Elements of Figure 14:
1)Mounting bracket
2)Regulatory label on the bottom of the unit
3)Rear panel
4)Power supply connector
5)Mounting bracket with power supply cradle
6)Front panel
2Attach the mounting brackets to each side of the unit using the four small black screws provided in the Accessory Kit (item 2 in Figure 23), and a #1 Phillips screwdriver.
When looking at the
On the ET0010A, the bracket that holds the power supply is on the left.
30 | ETEP Installation Guide |
