Installing the ET1000A
The steps to perform for a typical installation are listed below.
Table 16 | ET1000A Installation Steps |
| |
|
|
|
|
Step |
| Action to Perform | Description |
1 |
| Review the cabling requirements. | on page 41 |
1 |
| Unpack the shipping package. | on page 42 |
2 |
| Prepare a space for installation of the ET1000A. | on page 42 |
3 |
| Connect the cables. | on page 44 |
4 |
| Apply power to the ET1000A. | on page 45 |
|
|
|
|
Cabling Requirements: ET1000A
Table 17 outlines the standard cables used with each port on the ET1000A. The connector type listed indicates only what is required to connect to the ET1000A port, and may or may not be the same connector type required for the other end of the cable. Some cables are supplied by Black Box and others are
Table 17 | ET1000A Standard Cables |
| |||
|
|
| |||
ET1000A Port | Cabling | Supplied by... | |||
Power receptacles | Power supply cables certified | Black Box | |||
|
|
| and approved for use in the |
| |
|
|
| country of interest |
| |
Shielded copper null modem | Black Box | ||||
|
|
| cable, |
| |
|
|
| (female to male) |
| |
Ethernet Management Port | Shielded Category 5 straight | Black Box | |||
| through cable (STP), |
| |||
|
|
| connectora |
| |
Ethernet Management port | Not applicable. Port is not | Not applicable | |||
(SFP) |
| enabled in this release. |
| ||
Local and Remote Gigabit | • | Available as accessory options | |||
Ethernet ports |
| 9/125μm |
| ||
• | Optical SFP transceivers |
| fiber or simplex fiber pair (1 |
| |
| transmit, 1 receive), 1310 nm |
| |||
|
|
|
|
| |
|
|
|
| nominal wavelength, LC |
|
|
|
|
| connector |
|
|
|
| OR |
| |
|
|
| • |
| |
|
|
|
| 62.5/125μm |
|
|
|
|
| duplex fiber or simplex fiber |
|
|
|
|
| pair (1 transmit, 1 receive), |
|
|
|
|
| 850nm nominal wavelength, |
|
|
|
|
| LC connector |
|
Local and Remote Gigabit | Shielded Category 5 straight | Available as accessory options | |||
Ethernet ports | through cable (STP), |
| |||
• | Copper SFP transceivers | connector |
| ||
|
|
| |||
Aux1 port (SFP) | Not applicable. Port is not | Not applicable | |||
|
|
| enabled in this release. |
| |
|
|
|
|
|
|
a.The 10/100 Ethernet management port is
ETEP Installation Guide | 41 |