Installation
1ET10000A chassis
•Firmware and software is
2Accessory Kit
•Rack mount kit includes 2 mounting brackets, 16 small black screws, and 4 large silver screws
•
•
(2) Power cables (US)
(1)Shielded null modem cable with an
•
•
(1)6 ft. shielded Category 5 straight through cable (STP) with
Rack Mount Installation: ET10000A
The ET10000A can be mounted in a standard
To mount the ET10000A in a standard
•
•
•
Two mounting brackets, supplied in the Accessory Kit
16 small black screws, and 4 large silver screws
CAUTION
In order to safely and securely and install the ET10000A in a rack, you must use the mounting rails supplied in the Accessory Kit. Other rails may fail to properly support the weight of the ET10000A.
To install the ET10000A in a rack:
1Place the unit on a solid surface, with the top facing up. Position the mounting brackets on each side of the appliance, oriented as shown in Figure 36.
Figure 36 Mounting bracket orientation
2Attach the mounting brackets to each side of the unit using the small black screws provided in the accessory kit, and a #1 Phillips screwdriver, as shown in Figure 37. Each bracket uses 8 screws.
50 | ETEP Installation Guide |