Black Box ET1000A, ET0100A manual Powering On the ET0010A, ET0010A Cabling, To power on the ETEP

Figure 22 ET0010A Cabling

NOTE

The Aux1 port on the ET0010A is not enabled in this release.

Powering On the ET0010A

Use the following procedure to power up the ETEP.

Figure 23 Attaching the power cables on the ET0010A-402

To power on the ETEP:

1Check that the power supply cable is properly inserted in the power connector on the ETEP rear panel. The ET0010A-402 is shown in Figure 23. On the ET0010A, the power connector is on the right side of the rear panel.

2Plug the power cord into the ETEP power supply. Attach the opposite end to a power source to apply power to the appliance.

ETEP Installation Guide 35