Black Box ET0100A, ET1000A Entering a Throughput License, hour, 00-23, minutes, 00-59, seconds

Initial Setup

hour	00-23
minutes	00-59
seconds	00-59

3Type exit to return to the command prompt. Example

admin> configure

config> date 2008 10 11 15 30 00 config> exit

Entering a Throughput License

The method for entering licenses on the ETEP depends on your management software:

•

•

For ETEPs that are managed exclusively through the command line, follow the procedure in this section.

For EncrypTight Manager deployments, throughput licenses must be managed with the EncrypTight Manager software. Licenses entered from the CLI are not recognized as valid in a EncrypTight Manager deployment. See the EncrypTight Manager User Guide for more information.

Each ETEP is capable of transmitting traffic at a range of speeds that varies by model. When you install the license you purchased, ETEPs transmit traffic at the speed specified by the license.Table 23 lists the available speeds for each ETEP model.

Table 23	ETEP Throughput Speeds
Model		Available Throughput
ET0010A		3, 6, 10, 25, 50 Mbps
ET0100A		25, 50, 75, 100, 155, 250 Mbps
ET1000A		100, 155, 250, 500, 650 Mbps, 1 Gbps
ET10000A		500, 650 Mbps, 1, 2.5, 5, 10 Gbps

You need to install a license on each ETEP that you use. Licenses are linked to the serial number of the ETEP on which they are installed. You cannot install a license intended for one ETEP on a different ETEP.

If you upgrade from a command line-only installation to a full EncrypTight Manager deployment, you can no longer use the command line-only license and must acquire a license for EncrypTight Manager.

To add a license from the command line:

1At the command prompt, type configure to enter configuration mode.

2At the config> prompt, type license <string>, where string is the license provided by Customer Support. The license is case sensitive. Enter the license exactly as provided. It will look something like this: 1:0:0508C482:10:258482fab2

62 ETEP Installation Guide