Configuring the Management Port
Figure 42 Management Port Default Gateway
Elements of Figure 42:
1ETEP
2Router
3Management workstation
About auto-negotiation
The default setting for the ETEP enables
It is important to configure the ETEP and the other device the same way. Both devices should either auto- negotiate or be set manually to the same speed and duplex mode. Having one device set manually and the other
On the management port, the ETEPs can negotiate to the following link speeds:
Table 21 Link speeds on the management port
Link speed | Duplex mode | Fixed Speed | |
|
| All ETEPs | All ETEPs |
10 Mbps | | | |
|
|
|
|
10 Mbps | | | |
|
|
|
|
100 Mbps | | | |
|
|
|
|
100 Mbps | | | |
|
|
|
|
To configure the management port:
1At the command prompt, type configure to enter configuration mode.
2At the config> prompt, type
3Assigning an IPv4 address to the management port is mandatory. To set the management port IPv4 address, mask, and gateway, type
ETEP Installation Guide | 59 |