Installation
Cabling Requirements: ET10000A
Table 19 outlines the standard cables used with each port on the ET10000A. The connector type listed indicates only what is required to connect to the ET10000A port, and may or may not be the same connector type required for the other end of the cable. Some cables are supplied by Black Box and others are
Table 19 | ET10000A Standard Cables |
| |||
|
|
| |||
ET1000A Port | Cabling | Supplied by... | |||
Power receptacles | Power supply cables certified | Black Box | |||
|
|
| and approved for use in the |
| |
|
|
| country of interest |
| |
1.8 meter shielded null modem | Black Box | ||||
|
|
| able with an RJ45 connector at |
| |
|
|
| one end and a DB9 female |
| |
|
|
| connector at the opposite end. |
| |
10/100 Ethernet Management | Unshielded Category 5 straight | Black Box | |||
Port | through cable (STP), |
| |||
|
|
| connectora |
| |
Gigabit Ethernet Management | Not applicable. Port is not | Not applicable | |||
port (SFP) |
| enabled in this release. |
| ||
USB Management port | Not applicable. Port is not | Not applicable | |||
|
|
| enabled in this release |
| |
Local and Remote Gigabit | • | Available as accessory options | |||
Ethernet ports |
| 9/125μm |
| ||
• | Optical SFP transceivers |
| fiber or simplex fiber pair (1 |
| |
| transmit, 1 receive), 1310 nm |
| |||
|
|
|
|
| |
|
|
|
| nominal wavelength, LC |
|
|
|
|
| connector |
|
|
|
| OR |
| |
|
|
| • |
| |
|
|
|
| 62.5/125μm |
|
|
|
|
| duplex fiber or simplex fiber |
|
|
|
|
| pair (1 transmit, 1 receive), |
|
|
|
|
| 850nm nominal wavelength, |
|
|
|
|
| LC connector |
|
Local and Remote Gigabit | Unshielded Category 5 straight | Available as accessory options | |||
Ethernet ports | through cable (STP), |
| |||
• | Copper SFP transceivers | connector |
| ||
|
|
| |||
Aux1 ports (SFP and | Not applicable. Ports are not | Not applicable | |||
|
|
| enabled in this release. |
| |
|
|
|
|
|
|
a.The 10/100 Ethernet management port is
NOTE
To meet the requirements of FCC Part 15 and the EU EMC Directive 2004/108/EC, use only shielded Category 5 cables with the ET10000A Ethernet management port.
48 | ETEP Installation Guide |