![](/images/new-backgrounds/1261169/26116929x1.webp)
CLEANING & LUBRICATING
CleaningLubricating
Use an automotive grade solvent such as Sprayway
Do not allow dust, chips, or sand into the air connectors or into the body of the sta- pler; this may result in leaks and damage to the stapler and the air couplings.
Never use gasoline to clean this tool. Use extreme caution when using any solvent cleaner. Always clean the tool in a
Special pneumatic tool oil has been included with your new Grizzly stapler to help maintain its useful life. Place two to six drops of oil in the stapler air inlet (as shown in Figure 13) every two hours of continuous use.
Wipe off any excess oil near the stapler exhaust to avoid dust
An efficient alternative to oiling your tool by hand is to install a lubricator in your air compressor line. If your air compressor line already has a lubricator, then regular lubrication of your stapler will not be nec- essary. Just make sure there is always oil in the lubricator.
Figure 13. Lubricating the stapler at the
air inlet.
H7947/H7948 16 Gauge Stapler |