Grizzly H7947, H7948 instruction manual Compressed Air System

Compressed Air

System

The Model H7947/H7948 is designed to be operated at 70–110 PSI using clean, dry, regulated, compressed air. DO NOT exceed 120 PSI.

An in-line filter/lubricator/regulator unit, depicted in Figure 2, can be installed and should be located as close to the stapler as possible.

This filter/lubricator/regulator unit will pro- tect your tool from damaging water build- up, allow you to adjust and maintain con- stant air pressure to your tool, and save you the inconvenience of manually lubri- cating your tool every time you use it.

Check the current Grizzly catalog for avail- ability of this unit. If you plan on install- ing a filter/lubricator/regulator unit in your compressed air system, always follow the connection instructions that come with the unit.

Exceeding the maximum permissible operating pressure may damage the seals, gaskets and hammer mecha- nism of your stapler. DO NOT allow your air compressor to exceed the recommended pressure when con- nected to this stapler or serious per- sonal injury may result!

Quick	Quick	Lubricator
Connector	Connector		Regulator
Your			Air
Tool			Compressor
Quick
Coupler		Quick
	Air Hose		Filter
		Coupler

Figure 2. Typical filter/lubricator/regulator installation order.

-6- H7947/H7948 16 Gauge Stapler