SECTION 5: ASSEMBLY
Neck to the Body
Aprecise fit is important for the
Components and Hardware Needed: | Qty |
Neck | 1 |
Body | 1 |
Dowels | 2 |
Tailpiece | 1 |
Nut | 1 |
To install the neck: |
|
1.Test fit the neck by pushing the dowels into the body of the mandolin and sliding the neck onto the dowels as shown in Figure 5. DO NOT glue the joint at this time.
Figure 5. Test fitting the neck.
2.Check for gaps between the body and the neck.
H8067 Flat Iron Style Mandolin Kit
Figure 6. Adjusting the fit of the neck.
3. Dry fit the neck and mark the center of both ends of the body, and the neck.
4.Place a straightedge across your center marks as shown in Figure 7.
Center |
Line Marks |
Figure 7. Checking neck and body alignment
along center line.