Grizzly H8068 owner manual String Retainers, To install the strings using only the bridge

To install the strings using only the bridge:

1.Slide the 1st string through the corresponding hole in the bridge (Figure 29).

2.Repeat Steps 3-8in the previous subsec- tion.

Figure 29. 1st string installed.

String Retainers

Components and Hardware Needed:	Qty
Guitar	1
Retainer	1
Stainless Steel Screw #2 x 3/8"	1
Bushing	1

The string retainer mounts between the 1st and 2nd strings (Figure 30).

-20-

Retainer and

Bushing

Figure 30. String retainer locations.

To install the string retainer:

1.Place the string retainer on top of the 1st and 2nd string near the second tuner.

2.Using a 1⁄16" drill bit, drill 1⁄4" deep holes straight through the holes in the string retain- ers.

Note: Drilling the holes deeper than 1⁄2" could result in drilling out the bottom of the peghead.

3.Slide a #2 x 3⁄8" screw through a retainer and small bushing, and fasten it to the back hole on the headstock (Figure 30).

H8068 Telecaster® Style Kit