4.Solder the pickup wires to the volume and three way switch as shown in the Wiring Diagram on Page 29 and the Electrical Photos on Pages
5.Solder the audio jack wires onto the output jack.
Installing Output
Jack
Components and Hardware Needed: | Qty |
Output Jack | 1 |
Output Jack Cover | 1 |
Chrome Screws 3.1 x 12mm | 2 |
To install the output jack: |
|
1.Thread the output jack onto the jack cover.
2.Place the output jack cover in the jack cavity, and mark the mounting holes.
3.Using a 1/16" drill bit, drill 3/8" holes at a 45º angle into the body as shown in Figure 24.
Figure 24. Drilling output jack mounting holes.
4.Mount the output jack cover with two 3.1 x 12mm screws.
Installing Bridge,
Pickups & Controls
To reduce humming in your amp, the ground wire must contact the bridge plate.
Components and Hardware Needed: | Qty |
Guitar Body | 1 |
Pick Guard | 1 |
Chrome Screws 3.5 x 25mm | 4 |
Chrome Screws 3.1 x 12mm | 10 |
To install the control plate and pickups: |
|
1.Tape the ground wire so the exposed por- tion curls over the bridge cavity as shown in Figure 25.
2.Place the bridge into the cavity so the plate makes contact with the wire.
Ground Wire
