Grizzly H8070 owner manual Supplies/Tools, Recommended Tools & Supplies

Supplies/Tools

Most wood components in this kit are fully machined at the factory and are ready for assem- bly. A small amount of sanding and finishing is needed to complete your guitar.

Recommended Tools & Supplies:

•Sharp Pencil

•Drill Press

•Drill Bits: 1⁄16", 3⁄32", 5⁄32", 5⁄16", 11⁄32", 1⁄4"

•Electric/Cordless Drill

•Depth Stop

•NIOSH Approved Respirator

•ANSI Approved Safety Glasses

•Aluminum-Oxide Sanding Paper #150, #220 and #320 Grit

•Wet and Dry Sanding Paper #400, #600, and #1000 Grit

•Flexible Sanding Block

•Wood Glue

•Chisel or Razor Blade

•Phillips Screwdriver #1, #2

•1⁄4" Steel Rod or a Coat Hanger

•Masking Tape

•Tack Cloth

H8070 Heirloom Telecaster-Style Guitar Kit

•Bandsaw with 1/4" Blade or Coping Saw

•Tack Cloth or Soft Cloth

•Sanding Sealer

•Assorted Wood Files

•Buffing Compounds

•Oil Wood Finish

•Soldering Iron and Solder

•Peghead Reamer or a Round File

•Rubber Dead Blow Hammer

•Tweezers, Pliers, Wire Cutters

•C-Clamps

•Temporary Wood Handle: Approximately 1" x 2" x 16"

•Guitar Capo

•Feeler Gauge Set

•Spray Primer and Finish (See Note Below)

•18" Metal Straightedge (1⁄32" Resolution)

•36" Metal Straightedge

•Steel Ruler (1⁄64" Resolution)

•Wood Dowel

•Wood Blocks: 4" x 4" x 12" (2)

•Wood Shim: 7⁄16" Thick

Note: Use the same type of paint for primer and finish—either enamel or lacquer base. Do not use different base paints for priming or finishing or your results may not be desir- able.

-5-