Grizzly H8232 owner manual Replacing Pistons Rings, Nailer Repair Kit

Nose Cover	Nose Release
Nose Tip

Figure 11. Nose opened to clear a jam.

4.Dislodge the jammed nail with a tool that will fit in the slot on the underside of the nose.

5.Throw the damaged nail away and insert a new nail strip that only contains clean, undamaged nails. DO NOT use dirty or damaged nails!

6.Close the nose cover and replace the nose tip. Then release the catch lever and let the pusher slide to the front of the magazine.

Replacing Pistons/

O-Rings

Under heavy use, a piston, piston shaft, or O-ring may wear out. Replacement is quick and easy. Contact Grizzly Customer Service at (800) 523-4777 to obtain the fol- lowing Piston Repair Kits or the Complete O-Ring Repair Kits.

Nailer Repair Kit	Part Number
Framing Nailer:
Piston Repair Kit	PH7665095
O-Ring Repair Kit	PH7665096
Finish Nailer:
Piston Repair Kit	PH8232091
O-Ring Repair Kit	PH8232092
Palm Nailer:
Piston Repair Kit	PH6141026
O-Ring Repair Kit	PH6141027

Always disconnect air from nailer whenever servicing! During mainte- nance, a nailer connected to air may fire accidentally, causing serious per- sonal injury!

Framing & Finish Nailer

To replace a piston in your framing or finish nailer:

1.DISCONNECT NAILER FROM THE AIR SUPPLY!

2.Remove all nails from the magazine cartridge, and clean the exterior of the nailer.

3.Remove the four cap screws on the back of the nailer, near the exhaust port.

4.Remove the cap.

5.The top of the piston should now be visible inside the cylinder, which is housed in the head of the nailer.

6.Watch the discharge area and push the top of the piston with your finger. You will see the piston shaft slide down the discharge area.

Model H8232 3-Piece Framing/Finish/Palm Nailer Kit -13-