Grizzly Model G8592 instruction manual Before YOU Start, Unpacking, Initial Charging

BEFORE YOU START

Unpacking

When unpacking, check to make sure all of the following parts are included:

1Cordless Screwdriver w/ Battery

1Cordless Flashlight w/ Battery

1Charging Adapter

1 Bit Extension

1 Square Drive Adapter

1Double End Phillips®/Straight Bit

8Sockets (6mm - 13mm)

4Straight Blade Screwdriver Bits

4Phillips® Screwdriver Bits

4Posi-Drive®Driver Bits

8Torx® Driver Bits

8Hex Driver Bits

If any parts are missing, please contact Grizzly’s Customer Service department at the phone number provided on the Warranty/Returns page.

Fig 1. Kit Contents (case not shown).

Initial Charging

The batteries in your new Cordless Screwdriver/Flashlight Kit will not be fully charged when you receive it. To maximize

the storage capacity of the battery it should be completely discharged (turn the flash- light and screwdriver on and let them run until the batteries discharge), then fully recharge for 10-12 hours.

For optimal life span, completely discharge the battery after every use. Follow the instructions below to charge your battery NOTE: The battery does not need to be removed from the tool in order to be charged.

1.Plug the adapter into an appropriate 110/120V outlet.

2.Plug the other end of wire with the pin plug into the receptacle on the base of the Screwdriver or Flashlight bat- tery pack (See Figure 2).

3.Let the battery charge for 10-12 hours. This will give the battery a full charge. DO NOT let the battery charge for more than 12 hours.

4.When charging is complete, unplug the pin plug from the battery pack, and unplug the adapter from the wall outlet. The accessory should be ready to use.

Fig 2. Plugging charger into battery.

-6- G8592 3.6V Cordless Screwdriver/Flashlight