Grizzly T10043 instruction sheet Assembly, Hitch Pin

Assembly

1.Attach the hitch tubes to the sweeper assem- bly as shown in Figure 5. Do not tighten the hardware at this time. Refer to the inventory figures on Page 2 for hardware identifica- tion.

Note: Make sure the rear ends of the hitch tubes angle slightly upward, as shown in Figure 5, Detail A. If they angle downward, this means the left tube is positioned on the right side and vice-versa. Reverse the place- ment of the hitch tubes, then attach them.

Sweeper	A
Assembly
A
Hitch Tubes	B
W,X (x 2)	S,Z (x 2)
Upward Angle
Detail A	Detail B

Figure 5. Frame assembly.

2.Measure the height of the hitch on your riding lawn mower.

—If the mower hitch height is less than 11", then assemble the sweeper as shown in Figure 6.

—If the mower hitch height is more than 11", then assemble the sweeper as shown in Figure 7.

Assemble the hitch using the flat hitch brack- et, the raised hitch bracket, the M8-1.25 x 55 hex bolts, and two of the M8-1.25 hex nuts. Be sure the hex bolts fit between the hex bolts from Step 1 (Figures 6 and 7).

-3-

Flat Hitch Bracket	Hex Bolts
	Hex Nuts (Obscured
Raised Hitch Bracket	From View)

Figure 6. Hitches under 11".

Raised Hitch Bracket
	Hex Bolts
	Hex Nuts (Obscured
Flat Hitch Bracket	From View)

Figure 7. Hitches over 11".

3.Tighten all hardware from Steps 1 and 2.

4.Insert the hitch pin and the hitch spacers, and secure them with a 3mm hairpin cotter pin, as shown in Figure 8.

Hitch Pin

Spacers

Hairpin Cotter Pin

Figure 8. Hitch Pin.

T10043 38" Lawn Sweeper