Grizzly T10222 owner manual Router Installation, To install a router

Router Installation

The Model T10222 will support a router with a base thickness between 1⁄4" and 2⁜1⁄4".

To install a router:

1.DISCONNECT THE SAW AND ROUTER FROM POWER!

2.Slide three of the router hold-down assem- blies into the T-slots underneath the router table so that they allow room for the router base, as shown in Figure 19.

Note: To properly position the hold-down clamp, adjust the tightness of the hold-down knob and the adjustment bolt so that the clamp will allow room for the router base in the next step. If necessary, put the adjust- ment bolt jam nut on the other side of the clamp.

Router	Adjustment
Clamp	Bolt
Hold-Down
Knob

Figure 19. Router hold-down assembly controls.

If the router unexpectedly moves or the rout- er bit contacts the table insert or fence dur- ing operation, serious personal injury could result from flying debris. ALWAYS make sure that all four router clamps are used and are applied to the flat surface of the router base before connecting the router to power.

3.Slide the router base onto the three hold- down clamps, position them so that they secure the router bit in the center of the table opening, then tighten the hold-down knobs and adjustment bolts to secure the router in place (see Figure 20).

Figure 20. Router installed in the hold-downs.

4.Install the remaining hold-down assembly to make sure the router stays firmly in place dur- ing operation.

NOTICE

To prevent dam- age to the router table T-slots, do not position the clamp adjustment bolts over the thin edge of the T-slots.

Model T10222 (Mfg. Since 12/09) -13-