Grizzly T10726 owner manual Service, Troubleshooting, Symptom Possible Cause Possible Solution

SECTION 6: SERVICE

Review the troubleshooting and procedures in this section if a problem develops with your machine. If you need replacement parts or additional help with a procedure, call our Technical Support at (570) 546-9663. Note: Please gather the serial number and manufacture date of your machine before calling.

Troubleshooting

Symptom	Possible Cause		Possible Solution
Heavy resistance	1.	Machine capacities are exceeded.	1.	Use sheet metal that does not exceed 22 gauge
during bends.				mild steel.
	2.	Fingers not aligned with finger receiver	2.	Make sure fingers are aligned with finger receiver
		groove.		groove as fingers are lowered for bend.
Bend radius is not	1.	Machine capacities are exceeded.	1.	Use sheet metal that does not exceed 22 gauge
consistent across				mild steel.
workpiece.	2.	Bottom of fingers not aligned with each	2.	Make sure fingers are firmly seated in finger clamps
		other.		and the finger points are aligned with each other.
Point of fingers are	1.	Fingers not aligned with finger receiver	1.	Make sure fingers are aligned with finger receiver
chipping or rolling.		groove.		groove as fingers are lowered for bend. Replace
				fingers if damaged.
	2.	Machine capacities are exceeded.	2.	Use sheet metal that does not exceed 22 gauge
				mild steel. Replace fingers if damaged.
Workpiece shows	1.	debris on fingers or finger receiver.	1.	Clean fingers and finger receiver (Page 14).
scoring marks or	2.	Fingers or finger receiver has scratches.	2.	polish out scratches, and apply tape on the
scratches after				workpiece at the bend locations for protection.
bend.

Model T10726 (Mfg. Since 12/12) -15-