Grizzly T10726 owner manual Finger Alignment, To align the finger points

Finger Alignment

To produce straight bends, the finger points (see Figure 18) must all be aligned evenly.

When moving or re-installing the fingers, there is play in the vertical positioning which can be used to align the fingers.

Finger

Cap Screws

Finger

Clamp

Finger Points

Figure 18. Finger points and cap screws.

-16-

Look along the length of the fingers from the side to identify any finger point that is not aligned with the rest.

Tool Needed	Qty
Hex Wrench 6mm	1
To align the finger points:

1.loosen, but do not remove, the cap screws that secures the finger.

Note: It may be necessary to also loosen the cap screws on each side of the finger to relieve the pressure from the finger clamp.

2.Apply upward pressure to the finger to firmly seat it into the finger clamp.

3.observe the alignment of the finger points from the side again. If necessary, repeat this procedure to bring all fingers into alignment.

Model T10726 (Mfg. Since 12/12)