SECTION 2: SET UP
Unpacking
Your air compressor left our warehouse carefully packed. If you discover the air compressor is damaged after you have signed for delivery, please immediately
call Customer Service at (570) 546-9663 for advice.
Save the container and packing materials for possible inspection by the carrier or its agent. Otherwise, filing a freight claim can be difficult.
Assembly
To assemble the air compressor:
1.Remove all packing materials and any protective plastic bags and tags from the compressor.
2.Rotate the air filter cap clockwise to make sure the air filter is attached to the cylinder head, as shown in Figure 2.
Air Filter Cap
Figure 2. Air filter attached to
cylinder head.
3.Remove the oil fill cap (Figure 3) on top of the crankcase and add air compres- sor oil into the hole. When full, the oil level should be in the center of the sight glass.
Oil Fill
Cap 
Sight Glass
Figure 3. Oil cap and sight glass location.
Placement
Place the compressor on a stable and level surface in a clear and well ventilated area to prevent the motor from overheat- ing. When using the compressor at a job site or any other location, make sure that an adequate and properly fused power supply is available for this machine. Do not use extension cords with this machine.
The contacts of the compressor pres- sure switch spark when cycling the compressor motor ON and OFF. If any flammable gases are near the switch, ignition and explosion may occur, resulting in severe burns or death. NEVER place the compressor next to flammable liquids, gases, or in a paint spraying or gluing booth.
Model T21888 (Mfg. since 2/10)
