Grundig 800 MILLENNIUM manual Clock And Timer Functions, Setting Timer On/Off Times

CLOCK AND TIMER FUNCTIONS,

SETTING TIMER ON/OFF TIMES

Press and hold the button for approximately

2 seconds until the 'TIMER' annunciator turns on, and 'ON' flashes. The 'ON' Time will also be indicated in the frequency portion of the display (same readout format as the clock) as well as the number '1' or '2' displayed to the right of the time. The number '1' or '2' indicates which one of the two event timers you are programming.

Press the desired 'Direct-Key-Input' buttons to enter a new 'ON' time. Enter the time in 'HH:MM' and in 24 hour format.

Press the button to remove the 'ON' time, to use the timer as a Sleep timer. For a Wake timer, program an 'ON' time and remove the 'OFF' time.

To set the 'OFF' time, press the button again to display 'OFF' time.

Press the desired 'Direct-Key-Input' buttons to enter a new

'OFF' time. Enter the time in 'HH:MM' and in 24 hour format. Press the '' button to remove the 'OFF' time, if desired.

Press the button again to enter TIMER 2 'ON' time.

Press the button again to enter TIMER 2 'OFF' time.

Finally, press the button to save the settings and switch the display to normal readout values.

1)Example for Setting Timer '1'

With frequency displayed, suppose it is desired to set

Timer '1' for a local ON Time of '16:59' and an OFF Time of ' 18:01'.

Action:

Press and hold the button for 2 seconds.

Press the button sequence

Press

Press the button sequence

Press

If it is desired to set 'Timer 2', use the same procedure as that for 'Timer 1'. Otherwise,

Press , to exit the 'Setting Timer' operation and return to normal frequency display.

ENABLING/DISABLING TIMER OPERATION

Press the button.

The 'TIMER' symbol will light in addition to either or both the timer '1' or timer '2' indication. After 2 seconds with no entry, the display reverts back to frequency readout. Timer '1' can be disabled/enabled by pressing the '1' numeric digit on the 'Direct-Key-Input' keypad while the timer enable display is showing. Timer '2' can be disabled/enabled by pressing the numeric digit '2' on the 'Direct-Key-Input' keypad while the timer enable display is showing.

Prior to enabling either or both timers, consider one of two possible cases for each timer:

eg.) -To Enable TIMER '1' –

(1)'-' is displayed: Press the button to display '1'.

(2)'1' is displayed: Press the button twice to again display '1'.

It is important to note that the timer is enabled only when the timer is deliberately changed from a '-' to a '11', or to a '2'.

Even if the '1' or '2' is already displayed, the timer is not enabled unless the '-' to '1' or '2' transition occurs.

Setting a '-' for either timer DISABLES the respective timer.

22