POWER SUPPLY
AC ADAPTER
The SATELLIT 800 MILLENNIUM receiver is supplied with an
or nominal 230 VAC 50 Hz power.
The AC adapter is supplied with a North American type connector. To use the unit in countries using a European
type connector, plug the North American connector into the US to Europlug adapter that is provided.
Connect the output connector of the AC adapter to the 9 VDC, 1 amp connector on the back of the receiver. Inserted batteries are automatically disconnected as
soon as the AC adapter is plugged in to this connector.
Keep curtains and other flammable materials out of direct contact with the AC ADAPTER to avoid overheat ing.
GRUNDIG assumes no responsibility for damage due to operation with an AC adapter other than the one supplied with this unit.
BATTERY OPERATION AND INSTALLATION
The SATELLIT 800 MILLENNIUM receiver is designed to operate from either the supplied AC ADAPTER or from six "D" cell batteries (not supplied). NOTE: Check the batteries periodically for leakage. IF UNIT IS TO
BE STORED OR OTHERWISE NOT USED FOR AN EXTENDED PERIOD OF TIME, REMOVE THE BAT TERIES TO PREVENT CORROSION AND POSSIBLE DAMAGE TO THE RECEIVER.
Battery Installation
(1)Position receiver with the back panel towards you.
(2)Remove battery access cover by pressing on the corrugated area in the center of the cover and sliding it to your left as far as it will go. Then gently pull it straight out from the rear panel.
(3)Place 6 "D" cell alkaline type batteries into holder. Make sure the batteries are in the proper polarity posi tion as illustrated in Figure 1.
(4)Replace access cover by placing it over the left side of the opening and then sliding it to the right.
NOTE:
The SATELLIT 800 MILLENNIUM does not rely on the batteries for retention of memory channels. To ensure that clocks and timers are maintained following the loss of AC power or battery removal, the receiver must first be connected to a source of AC power or have batteries installed for a minimum of 10 minutes. If power is lost after this minimum 'charge' time, clocks and timer settings are maintained for a time period of approxi mately 30 minutes.
8