Please note the following instructions when set- ting up the system:
7The device is designed for the playback of audio signals. Any other use is expressly pro- hibited.
7If you want to set up the device on wall shelves or in cupboards, please ensure that it is adequately ventilated. There must be at least 10 cm of space at the side, above and behind the device.
7Do not cover the device with newspapers, table cloths, curtains, etc.
7When setting up the device, remember that furniture is often coated with various types of varnish and plastic, which often contain chemi- cal additives. These additives may cause cor- rosion to the feet of the unit. This may leave stains on the surface of the furniture which can be difficult or impossible to remove.
7If the device is exposed to sudden changes in temperature, for example when taken from the cold into a warm room, wait at least two hours before using it.
7The device is designed for use in dry rooms. If you do use it outdoors, make sure it is pro- tected from moisture such as dripping or splashing water.
7Only use the device in a moderate climate.
7Do not place the device close to heating units or in direct sunlight, as this will impair cooling.
7Do not place any vessels containing liquids, such as vases, on the device.
7Do not place any objects such as burning can- dles on the device.
7Thunderstorms are a danger to all electrical devices. Even if the device is switched off, it can be damaged by a lightning strike to the mains or the antenna cable. Always discon- nect the mains during a storm.
7Continuous use at high volume level can cause damage to the user’s hearing.
7If malfunctions occur due to static electricity charges or brief mains voltage surges, reset the device. To do this, pull out the mains adapter and connect it again after a few sec- onds.
7Do not open the device casing under any cir- cumstances. Warranty claims are excluded for damage resulting from improper handling.
7When the main plug or an appliance coupler is used as the disconnect device, the discon- nect device shall remain readily operable.
Note:
7 Do not connect any other equipment while the device is switched on.
7 Switch off the other devices as well before connecting them.
7 Only plug the device into the mains socket after you have connected the external de- vices.
7 Make sure the power plug is freely acces- sible.
