b. TV/Monitor
Symptom | Remedy |
| |
|
| ||
| 1. Check whether the power plug is connected to the power | ||
No power |
| supply. |
|
| 2. Pull out the plug and wait for 60 seconds, and then insert | ||
|
| the power plug again and switch on the TV/monitor. |
|
|
|
|
|
| 1. | Check whether the antenna is connected properly. |
|
| 2. | Adjust to another channel. |
|
No picture | 3. | Change the length and the contrast setting. |
|
| 4. | Make sure that the AV picture input cable is connected | |
|
| properly. |
|
|
|
|
|
| 1. | Increase the volume value. |
|
| 2. | Check whether the TV is at MUTE mode. |
|
No sound | 3. | Make sure that the sound system setting is proper. |
|
| 4. | Ensure the AV audio signal input cable is connected | |
|
| properly. |
|
|
|
|
|
| 1. | Ensure that the equipment is connected properly. |
|
Color distortion | 2. | Ensure that the AV video signal input is connected | |
|
| properly. |
|
|
|
| |
Pictures/sound are | 1. | Check whether the equipment is connected properly. | |
interfered | 2. | Adjust the antenna if use an outdoor antenna. |
|
|
|
| |
| 1. | Make sure that the batteries are installed with correct | |
|
| polarities. |
|
Remote control no | 2. | Clean the remote sensor. |
|
function | 3. | Ensure that there is no foreign object between the | |
|
| remote control and the sensor. |
|
| 4. | Operate the remote control at a distance not more | |
|
| than 6 meters from the remote sensor |
|
|
| ||
Screen glittering | Reset the computer and enter into the safety mode, then | ||
under PC mode | select the appropriate screen type by consulting | the | |
| operation manual. |
| |
|
|
| |
Screen traversed | Maybe the phase is not appropriate. Enter into the | PC | |
under PC mode | setting and change to correct level. |
| |
|
|
|
|
29