3. Assembly

Sweep Tractor Assembly

1.Place the tractor frame on plain flat ground and remove the bolts from the tractor frame.

2.Bolt the pillow block bearing to the bearing mount bracket using two (2) 1/2"-13 x 2" hex head cap screws, two (2) flat washers, and two (2) 1/2"-13 serrated flanged nuts.

3.Bolt the bearing mount bracket to the tractor frame using two (2) 1/2"-13 x 1-1/4" flanged bolts and two (2) 1/2"-13 serrated flanged nuts on either side (L.H. and R.H.) of the tractor frame.

NOTE: Lock collar flange must be to inside of frame.

 

 

 

 

NOTE: Left Hand and Right Hand is determined

 

 

Tractor frame

 

from the BACK of the tractor frame throughout

 

 

 

 

 

 

 

the manual.

 

 

 

 

 

Right Hand

Front

1/2"-13 x 1-1/4" Flanged bolts

Back

Left

Hand

1/2"-13 Serrated flanged nut

Bearing mount bracket

Pillow block bearing

1/2" Flat washer

1/2"-13 x 2" Hex head cap screws

Figure 3A

12

PNEG-1597Sweep Tractor Assembly Instructions

Page 12
Image 12
GSI Outdoors PNEG-1597 manual Sweep Tractor Assembly, Back Left Hand