
General Operation
•The EG1400 is controlled by the on/off power control switch located on the hose handle. The headlight will operate when the EG1400 is turned on.
•To lower wand from the upright position, simply press on the handle release pedal.
•The powerhead has a pile height pedal Fig. D
for various carpet heights. (Fig. D) Select a pile height setting by pressing the small pedal on the rear of the EG1400. Use the extra low setting for short napped carpets and the high setting for plush carpets.
CAUTION: Do NOT leave the EG1400 running in one spot in the upright position for any length of time. Damage to carpet may occur.
Attachments
Using attachments on the hose handle: | Fig. E | |
1. | Press handle quick release button, then pull up on | |
| handle. (Fig. E) NOTE: if the EG1400 is |
|
| attached, turn the powerhead off before removing |
|
| handle from wands. |
|
2. | Slide attachments firmly on hose handle as needed. | |
| In some cases, the button may need to be |
|
| depressed to allow the attachment to slide up |
|
| higher where it can seal on the metal tube. |
|
|
| |
Using attachments on wands: | Fig. F | |
1. | To remove the wands from the EG1400, lock wands | |
| in |
|
2. | Press wand quick release pedal with foot and pull |
|
| straight up out of the EG1400. (Fig. G) The plug |
|
and cord do not have to be removed to use | Fig. G |
| |
attachments on wands. |
|
3.Put attachment on wands as needed. In some cases, the button may need to be depressed to allow the attachment to slide up higher where it can seal on the metal tube.