Maintenance and Care

To Replace Belt:

Fig. L

 

1.Install new belt (Part # 9439-01) over motor drive then over belt path. (Fig. L)

2.Place agitator assembly back into EG1400. (Fig. M)

3.Reinstall agitator cover by lining up the front tabs and slots and rotating downward until the latches snap into place. (Fig. N)

4.Line up front of cover and base. Rest

cover on front edge of base as shown. (Fig. O)

5.Rotate cover back. Press cover firmly until side and rear tabs snap into place. (Fig. P)

6.Turn EG1400 upside down and replace 2 cover screws.

Fig. M

Fig. N

Fig. O

Fig. P

Light Bulb Changing

1.Remove EG1400 cover as shown in Belt Changing & Agitator Cleaning.

2.Push in and turn bulb coun- terclockwise, then pull out to remove. (Fig. Q)

Fig. Q

3. Push in and Fig. R turn bulb clockwise to replace.

Bulb must not be higher

than 15 Watts (130 Volts). (Fig. R)

4.Reinstall EG1400 Cover as shown in Belt Changing & Agitator Cleaning.

Page 9
Image 9
H-P Products EG1400 owner manual To Replace Belt