ELECTROGLIDE 9
MAINTENANCE AND CARE
Belt Removal and Replacement
The belt should also be checked periodically to be sure it is in good condition. It should be replaced if it is stretched, cracked or broken. If the belt needs replaced, use only Electroglide Belt # 7960.
To remove belt:
1.Remove light cover and light bulb as shown on Page 8.
2.Unscrew the Electroglide Powerhead cover screws.
3.Turn Electroglide Powerhead over. To remove cover, insert screwdriver at cover tabs on both sides and twist to release tabs.
Tab
4.Turn Electroglide Powerhead right side up. Press handle release pedal and lower the swivel. Tilt cover forward from back until front snaps free.
Easy |
Release |
5.Carefully insert and twist screwdriver at each brush support to free brush from base.
Base |
Brush |
Support |
