Cal Spas LTR20101000 Operating Your Spa, Operating SpaYour, and 6300 Control Panel, Portable Spa

12

Operating SpaYour

Operating Your Spa

5100, 6200 and 6300 Electronic Control Operation

These instructions will describe features and options that your particular spa may not be equipped with.

5100 Control Panel (one and two pump systems)

6200 and 6300 Control Panel

Initial Start up

When first powered up, your spa will perform a self- diagnostic check and go into priming mode. The topside will display PR to indicate this. Priming mode will be active for less than five minutes.

Sometimes the pump fails to prime, especially when spa owners do not fill their spas through the filter canister. You can avoid priming problems by following these steps during priming mode.

1.Press the JETS button to turn on the pump and let it run for 10 seconds. The pump should be running in low speed.

2.Press the JETS buttons again and let the pump run in high speed for 10 seconds.

3.Press the JETS button again to turn off the pump. The pump should be left in the off position for 10 to 15 seconds.

4.Repeat steps 1 through 3 until water is flowing through all the jets and all air is removed from the plumbing.

When the spa has finished priming, the heater will be activated and the water temperature will be maintained in standard mode. The spa will heat to 100°F (37.5°C) at start up until the set temperature is changed as described below.

Temperature Adjustment

(Range 80°F to 104°F, 26°C to 40°C)

The electronic control panel displays the actual water temperature in degrees Fahrenheit. The displayed temperature will only be current after the pump has been running for at least two minutes.

To display the temperature that the spa is set to:

•Press the Temp button. The temperature setting will flash.

•While the display is flashing, each time you press

Temp button, the set temperature will change up or down one degree.

•If the desired temperature is opposite of the direction each press of the button is making, release button, allow display to stop flashing and then press Temp button to change temperature the other direction.

2010 Portable Spa

www.calspas.com LTR20101000, Rev. C