Cal Spas LTR20101000 Adjustable Therapy System, Wireless Spa Monitor, Pump On/Off, Pulse Mode

22

Operating SpaYour

Adjustable Therapy System

Pump On/Off

This button allows the user to turn on and off the ATS seat pump. Press this button once to turn the pump on. Once on, the green LED light on the control panel will illuminate, indicating that the system is operational. To turn off the pump, press the “PUMP ON/OFF” button a second time. Note: The pump must be on prior to operating any other features of this system.

Pulse Mode

This button allows the user to turn the ATS massage control on and off. Press the pulse button once to turn on the massage control. Once pressed, the orange LED in position number 1will light, indicating the number one pulse mode. Each press of either the up or down button will move the orange LED up or down to the next pulse mode.

Note: Allow one second between each button press. Pressing the button quickly may cause improper operation. To turn the pulse mode off and return to normal pump operation, press the “PULSE MODE” button a second time.

Up

This button allows the user to cycle up from one through seven massage modes one at a time. Each mode offers a different pulsating massage. Some modes are faster than others, so just cycle through them to find the massage you like best.

Down

This button allows the user to cycle down through all seven massage modes, one at a time.

Time Reset

Mode

Pulse mode will normally run for 15 minutes then automatically shut off. For another

15-minute session, press the “PUMP ON/OFF” button and the “PULSE MODE” button. A

green LED will blink and the pump will run on high- speed mode as part of a 15-minute cool down period. After that, the pump will stop automatically and the green LED light on the panel will continue to blink for one minute then shut off automatically. After the second 15-minute session, the system will run through a cool down cycle for up to two hours. In this cool down mode, the user will only be able to operate the pump (by again pressing the “PUMP ON/OFF” button). However, the massage mode will remain off until the cool down mode is completed.

Pulse Mode System

Pulse mode system will shut off for two hours unless reset by the following procedure. During this time the pump will run at a maximum speed.

•In the off position, press the “PULSE MODE” button once.

•The green power light will flash to indicate reset.

Wireless Spa Monitor

The wireless spa monitor allows you to monitor and change your spa’s activity from a distance. The table below describes each button’s function.

Light Operates spa light and LED mood lighting

Temp Display or adjust the set temperature control

Jet 1 Turn on or off jet 1

Mode Switch between Standard, Economy, and Sleep Modes

2010 Portable Spa

www.calspas.com LTR20101000, Rev. C