H-P Products Electroglide Belt Removal continued, To replace belt, Maintenance And Care

Models: Electroglide

1 16

Page 10

10ELECTROGLIDE

MAINTENANCE AND CARE

6. Remove worn belt.

7. Slide brush supports off to check and clean brush support areas.

1.Slide washers and brush supports onto brush assembly.

3.Snap brush supports into place on base. Be sure brush supports are not upside-down.

2.Install new belt over motor drive, then over brush sprocket.

4.Line up front of cover and base. Rest cover on front edge of base as shown.

Cover

Base

Image 10

Contents

ELECTROGLIDE ELECTRIC POWERHEADElectroglide Electric Powerhead Review this manual before operating yourTABLE OF CONTENTS IMPORTANT SAFETY INSTRUCTIONS SAVE THESE INSTRUCTIONSPARTS AND FEATURES 4ELECTROGLIDEHose Handle Handle Button Upper Wand Button Lock ASSEMBLING VACUUM SYSTEMSuction Control Plug Holder Power Cord Cord Wand SwivelELECTROGLIDE ATTACHMENTS Wand Assembly AttachmentsGENERAL OPERATION Hose Handle AttachmentsOverload Protector PERFORMANCE FEATURESEdge Cleaner Suction ControlLight Bulb Replacemnent MAINTENANCE AND CAREBrush Cleaning for your ElectroglideTo remove belt Belt Removal and ReplacementMAINTENANCE AND CARE To replace belt Belt Removal continuedMAINTENANCE AND CARE Brush Replacement Belt Replacement continuedMAINTENANCE AND CARE ELECTROGLIDE REPLACEMENT PARTS 12ELECTROGLIDEDescription IllusPart ELECTROGLIDE REPLACEMENT PARTSLIMITED WARRANTY 14ELECTROGLIDE512 W. GORGAS STREET LOUISVILLE, OHIO SERVICE INFORMATIONH-PPRODUCTS, INC ELECTROGLIDEHVS-968-NL H-PProducts, Inc512 W. Gorgas Street Louisville, Ohio 02/02