h2oaudio.com
Waterproof Headphone System
Developed for Swimming
Before using this system, please be sure to read, understand, and follow the instruction of this manual.
Installing the shuffle into the case
1 | 2 |
Open Case
3 | 4 |
Plug audio jack into the shuffle player, place shuffle into case and ensure the control pad and the Button Pad Control are aligned. Close case.
5 | Close Case | 6 | Ensure the case is |
|
|
closed and locked.
Introduction
The H2O Audio Interval Waterproof Headphone System is a swim specific music solution for the iPod shuffle (2nd Gen). The integrated waterproof case easily attaches to practically any swim goggle providing a low profile, tangle free listening experience.
Getting Familiar with Your Headphone System
Before using your Interval Waterproof Headphone System for the first time, it is highly recommended that you become familiar with opening and closing the case to ensure the case is sealed properly during use. To verify that you have sealed the case properly we recommend that you test the product without a shuffle inside before initial use. Please follow the instructions below.
1.Open the case and verify the seal area is clean and free of debris or damage.
2.Submerge the system in water and soak for 30 min.
3.Manipulate the Button Control Pad during submersion.
4.Remove from water and dry exterior.
5.Open the housing and ensure there is no water inside the case.
If water is found inside the case please contact H2O Audio Customer Support immediately.
Copyright Notice:
This owner’s manual is copyrighted, all rights reserved. It may not, in whole or in part, be copied, photocopied, reproduced, translated, or formed into any electronic format without prior consent in writing. H2O Audio is a registered trademark of H2O Audio, Inc. Apple and iPod are registered trademarks of Apple Inc.
Important Seal Information
The Interval Waterproof Headphone System features a removable silicone seal that forms a waterproof barrier between the base and lid of the case. It is extremely important that special attention is paid to ensure the silicone seal is completely seated in the groove of the lid. If the seal is loose, out of alignment, twisted or pinched in any way, it will compromise the waterproof integrity of the case and should not be used. Any debris such as hair or sand will keep it from forming a watertight barrier and should be cleaned off before use.
If you have any concerns please contact H2O Audio Customer Support.
Caution: If the seal comes out of alignment, carefully place it in the groove, ensuring all 4 corners are correctly installed. Compress the lid to the base and then
Button Pad Control
Volume up
Previous / Rewind
Button
Next / Fast -
Forward Button
Play / Pause Button
Volume down
