Haier AC182XCERA, AC142XCERA operation manual HOW to Connect Wiring to the Terminals

Installation Procedures

HOW TO CONNECT WIRING TO THE TERMINALS

A.For solid core wiring (or F-cable)(Fig.24A)

(1)Cut the wire with a wire cutter or wire-cutting pliers, then strip the insulation to about 25mm of the exposed solid wire.

(2)Using a screwdriver, remove the terminal screw(s) on the terminal board.

(3)Using pliers, bend the solid wire to form a loop suitable for the terminal screw.

(4)Shape the loop wire properly, place it on the terminal board and tighten securely with the terminal screw using a screw driver.

B.For strand wiring(Fig.24B)

(1)Cut the wire with a wire cutter or wire-cutting pliers, then strip the insulation to about 10mm of the exposed strand wiring.

(2)Using a screwdriver, remove the terminal screw(s)on the terminal board.

(3)Using a round terminal fastener or pliers, securely clamp a round terminal to each stripped wire end.

(4)Position the round terminal wire, and replace and tighten the terminal screw using a screw driver.

Fig. 24 A. Solid wire

B. Strand wire

Strip 25mm

Loop

Insulation

Strip 10mm

Round terminal

Wire

Screw with special washer

Round terminal

Terminal board

Screw with special washer

Round terminal

Wire

HOW TO FIXED CONNECTION CORD AND POWER CABLE AT THE CORD CLAMP

After passing the connection cord and power cable through the insulation tube, fasten it with the cord clamp, as shown in Fig.25

Fig. 25 Insulation tube

Cord clamp

Use VW-1, 0.5 to 1.0 mm thick, PVC tube as the insulation tube.

14