Operation
Timer On/Off On-Off Operation
1.After unit starts, select your desired operation mode.
2.Press TIMER button to change TIMER mode. Every time the button is pressed, display changes as follows: Remote controller:
BLANK
0.5h | 0.5h | 0.5h | 0.5h |
TIMER ON | TIMER OFF | TIMER | TIMER |
Then select your desired TIMER mode (TIMER ON or
TIMER OFF or TIMER
3.Press / button to set time.
Press the button for each time, setting time in the first 12 hours increased by 0.5 hour every time, after 12 hours,increased by 1 hour every time.
Press the button for each time, settiing time in the first 12 hours decreased by 0.5 hour every time, after 12 hours,decreased by 1 hour every time.
It can be adjusted within 24 hours.
4.Confirm timer setting
After adjust the time,press | button and confirm the |
time ON or OFF button will not flash any more.
5.Cancel timer setting
Press the timer button by times until the time display eliminated.
Hints:
After replacing batteries or a power failure happens, time setting should be reset.
According to the Time setting sequence of TIMER ON or
TIMER OFF, either
Health airflow Operation
1.Press to starting
Setting the comfort work conditions.
2.The setting of healthy airflow function
Press button to select “ Healthy airflow”, the remote
controller will switch as below
Healthy | Healthy | fixed |
| |||
airflow |
| airflow |
|
| ||
upwarder | downwarder | location | ||||
|
|
Notice: Do not direct the flap by hand. Otherwise, the grille will run incorrectly. If the grille is not run correctly,
stop for a minute and then start, adjusting by remote controller.
Note:
1.After setting the healthy airflow function, the position grill is fixed.
2.In cooling, it is better to select the |
| mode. |
|
3.In cooling and dry, using the air conditioner for a long time under the high air humidity, condensate water may occur at the grille .
5