Getting to know your dishwasher | EN |
|
|
Close-up view (control panel)
C
A | B |
A | C Programme Indicator |
BProgramme Button
Models explanation
Model | Colour |
|
|
White | |
|
|
Silver | |
|
|
Stainless Steel | |
|
|
You can select dishwasher with big handle or without big handle according to requirement.
Dishwasher interior
| e |
|
|
a |
|
| j |
|
|
| |
| c | f | k |
|
|
| |
b | d | g | l |
h |
| ||
|
| i |
|
a | Upper Rack | g | Salt Container Cap |
b | Lower Rack | h | Washing Filter |
c | Top Spray Arm | i | Detergent and Rinse Aid Dispenser |
d | Silverware Basket | j | Water Inlet Hose (some models with “Aquastop”) |
e | Third Sprayer | k | Drain Hose |
f | Bottom Spray Arm | l | Power Supply Cord |
How to fill the salt
Salt
The hardness of the water varies from place to place. If hard water is used in the dishwasher, deposits will form on the dishes and utensils.
The appliance is equipped with a special softener that uses a salt specifically designed to eliminate lime and minerals from the water.
Loading the salt into the container
Always use salt intended for use with dishwashers.
The salt container is located beneath the lower rack and should be filled as follows:
According to the “Water Hardness Tabel”, you can calculate the time of use , then load the salt .
Remove the lower rack and then unscrew and remove the cap from the salt container.
If you are filling the container for the first time, fill it with water.
Place the end of the funnel (supplied) into the hole and introduce about 2 kg of salt. It is normal for a small amount of water to come out of the salt container. Carefully screw the cap back on.
Important
To prevent the formation of rust, load the salt just
before beginning a wash cycle.
Adjusting salt consumption
The dishwasher is designed to allow for adjusting the amount of salt consumed based on the hardness of the water used. This is intended to optimize and cus- tomize the level of salt consumption so that it remains at a minimum.
To adjust salt consumption, proceed as follows:
Unscrew the cap from the salt container;
There is a ring on the container with an arrow on it (see figure to the side). If necessary, rotate the ring in an anticlockwise direction from the
It is recommended that adjustments be made in accordance with the following table:
| Water Hardness |
|
|
|
| ||
|
|
|
|
|
|
|
|
|
|
|
|
| Selector | Salt | Autonomy |
Level |
| Clarke | º dH |
| c o n s u m p t i o n | ||
| mmol/l | (cycles/2kg) | |||||
|
| degrees |
|
| position | (Grams/cycle) |
|
|
|
|
|
|
|
|
|
1 |
| 014 | MNT | MNIT | L | M | L |
|
|
|
|
|
|
|
|
2 |
| NQPS | NUQQ | NIUQIQ | =?J? | OM | SM |
|
|
|
|
|
|
|
|
3 |
| PSTN | QRUV | QIRUIV | jba | QM | QM |
|
|
|
|
|
|
|
|
4 |
| [TN | [UV | [UIV | ?H? | SM | OR |
|
|
|
|
|
|
|
|
4