Haier DW12-TFE5 Installation

Positioning the appliance in the desired location. The back of the appliance should rest against the wall,

and the sides, along the adjacent cabinets or wall. The dishwasher is equipped with water supply and

drain hoses that can be positioned to the right or the left to facilitate proper installation.

Once the appliance is positioned, adjust the feet (screwing them in or out) to adjust the dishwasher,

making it level. The appliance should not be inclined more than 2˚. If the appliance is level, it will help

ensure proper performance.

Installation

fig.A

Connect the water supply hose to a threaded 3/4 (gas) connector,

making sure that it is fastened tightly in place (see fig.A).

Some models are fitted with an "Aquastop" water supply hose

(see fig.B) in which the small filter is already housed in the

threaded end.

If the water pipes are new or have not been used for an extended

period of time, let the water run to make sure that the water is

clear and free of impurities. If this precaution is not taken, there

is a risk that the water inlet can get blocked and damage the

appliance.

The dishwasher is equipped with a system that stops the supply of water in the event of a problem with the water

supply hose, or leaks within the unit, in order to prevent damage to your home. If for any reason the box contain-

ing the electrical components happens to get damaged,

turn off the power supply and

remove the plug for the

appliance from the socket immediately. In order to guarantee that the anti-flooding feature operates properly, the

"A" box with water supply hose must be attached to the water supply tap as shown in fig.B. No other type of

connection is acceptable.The water supply hose must not, under any circumstances, be cut, as it contains

electrical parts which are live. If the length of the hose is not adequate to make a proper connection, the hose

must be replaced with one which is long enough. This hose is available upon request from specialised retailers

and

approved

service center.

fig.B

The appliance is to be connected to the

water mains using new hose-sets and

that old hose-sets should not be reused.