EN
Washing dishes

Programme selection

The most appropriate programme can be identified by comparing the type of crockery, cutlery, etc., as
well as the amount and condition of food remains, with the details contained in the wash cycle table.The
corresponding programme sequence, duration and consumption details are shown in the right half of the
overview. For example:
Use the« normal» programme for dishes and u tensils which have plenty of food remains stuck on hard.

Energy saving

If only a small number of dishes have been loaded into the dishwasher,selecting a programme that
operates at the next lowest temperature which should be sufficient.

Programme data

The stated programme data are based on standard operating conditions. The values can vary consider-
ably according to:
different amounts of dishes
temperature of mains water supply
pressure of mains water supply
ambient temperature
fluctuations in mains voltage
machine-related factors (e.g. temperature, water volume,...)

Switching the dishwasher ON

Turn on the tap.
Close the door after loading the appliance
Set On-Off button “B” to On. The state indicator "A" light.
Rotate the knob to select programme you wish.
The time-remaining indicator display
the time of the programme you selected.
After 3 seconds the appliance emits a short warning signal,
and start the programme, the state indicator "A" blinks .

Warning

When the dishwasher is switched on, the program will not start until the program
selector knob has been turned to “Reset” and back to the selected wash program.
Then there will be a delay of approximately 30 seconds before the dishwasher
starts.
B
A
D F
C
G
E
I
H
15