EN
Interrupting the programme
Open the door. Caution! There is a risk o f water squirting out from inside the appliance. Do not open
the door fully until spray arm has stopped rotating.
When you open the door, the dishwasher will beep ten times every thirty seconds.
If the appliance has already heated up or the hot water was switched ON and then the appliance door
opened, leave the door ajar for several minutes and t hen close. Otherwise, the appliance door may
open
When you close the door after interrupting the wash program there will be a delay of approximately 30
seconds before the dishwasher re-starts the wash cycle
due to expansion.
Delayed start programming
You can delay the sta rt of a programme in inc rements of 1 hour up to 24 hour s.
Switch dishwasher ON.
Immediately press the Delayed Start button “ F ”, the delayed start indicator “ E ” blinks, the remain-
ing time indicator “ G ” changes to “ ”.
Press the Delayed Start button for 2 seconds until the numerical display show the required delay.
To cancel the time delay setting, pressing t he Delayed Start button until the delayed start indicator
“ E” goes out.
Rotate programme knob “ J ” to select the desired programme.
Close the door after load ing the appliance.

Notice:

When the appliance is already underway press the button "B" for 3 seconds, all of
the settings will be cancelled.
End of programme
Six beeps will indicate that the wash cycle has finished and the state in dicators "A" light.
Switching the dishwasher OFF
Several minutes after the programme has ended:
Set On-Off button to Of f
Open the door .
Turn the water tap of f.
Remove dishes, etc. whe n they have cooled down.
B
A
D F
C
G
E
I
H
J
16