Haier DW12-TFE5 Reset drain function, Cancelling or modifying a cycle

After 3 seconds the delayed start indicator “ E ” blinks, the time-remaining indicator “ G ” will blink and

decrease , the programme will start until the delayed start indicator “ G ” goes out .

Reset drain function

You can use Reset drain function to stop the washing cycle under running by Rotating the knob to

"Reset ", and the appliance will stop after a few minutes drain phase.

Cancelling or modifying a cycle

A cycle that is underway can be modified if it has only been running for a short time. Otherwise, the

detergent may have already been used, and the appliance may have already drained the wash water.

If this is the case, the detergent dispenser must be refilled ( see the paragraph entitled, “ Loading the

detergent ”).

To modify a cycle that is already underway, follow the instructions contained in the paragraph entitled

"Reset drain function", and select the programme you wish (see the paragraph entitled, "Switching

the dishwasher ON").

This button (see" Close-up View (Control Panel), letter " D ") makes it possible to wash dishes using only

the upper rack if there are not enough dishes for a full load. This will allow you to save on water and

energy consumption.

To select 1/2 load:

Press the 1/2 load button “ D ” , 1/2 load indicator “ C ” lights.

Select the programme ( see the paragraph entitled“ Switching the dishwaher ON”)

If the door is closed, after 3 seconds, the programme starts automatically.

- Please keep in mind that the amount of detergent should also be adapted to the 1/2 load.

- To cancel the 1/2 load, you can press the 1 /2 load button “ D ” again ,until the 1/2 load indicators

“ C” goes out.

D F