Cancelling or modifying a cycle, Goes out | Haier DW15-PFE1 specs

Cancelling or modifying a cycle

A cycle that is underway can be modified if it has only been running for a short time. Otherwise, the detergent may have already been used, and the appliance may have already drained the wash water. If this is the case, the detergent dispenser must be refilled ( see the paragraph entitled, “ Loading the detergent ”).

To modify a cycle that is already underway, press the button“A ” , all of the settings will be cancelled. To set a new cycle, follow the instructions contained in the paragraph entitled “Switching the dish- washer ON”.

A

1/2 Load Button (for DW15-PFE2**)

This button E (see" Close-up View (Control Panel), letter " B ") makes it possible to wash dishes using only the upper rack if there are not enough dishes for a full load. This will allow you to save on water and energy consumption.

To select 1/2 load:

Select the programme ( see the paragraph entitled“ Switching the dishwaher ON”)

Press the 1/2 load button “B ” , 1/2 load indicator “C ” blinks.

If the door is closed, after 5 seconds, the programme starts automatically.

-Please keep in mind that the amount of detergent should also be adapted to the 1/2 load.

-To cancel the 1/2 load, you can press the 1/2 load button “B ” again ,until the 1/2 load indicators

“C” goes out.

C

B

21

Image 23

Haier DW15-PFE1 manual Cancelling or modifying a cycle, Load Button for DW15-PFE2, To select 1/2 load, Goes out

Contents

Dishwasher DW15-PFE1**/PFE2 Instructions for Use Page Index During normal use Safety informationDuring installation At time of delivery If your family includes children If a fault occursWhen disposing of old appliances Cold water connection InstallationPositioning the appliance Levelling the appliance Electrical Connection Drain hose connection Please follow below pictures step by step How to remove the top of your dishwasher DW15-PFE1 DW15-PFE2 Getting to know your dishwasherClose-up view control panel Models explanation Dishwasher interior For DW15-PFE1 How to fill the saltSalt Loading the salt into the container Water Hardness Adjusting salt consumption Loading the rinse aid How to fill rinse aidRinse aid Damage to glassware and other dishes Not suitable for the dishwasherWhat you should not put into the dishwasher Our recommendation Pull out the rack to load the dishwasher How to use the lower rackHow to use the upper rack Knife rack Shelf Loading the detergent How to fill the detergent dispenserDetergent Soak Programme overview EN50242 test with rinse aid setting Programme data Washing dishesProgramme selection Earn savings Turn on the tap Switching the dishwasher onSwitching the dishwasher OFF End of programme Interrupping the programme Delayed start programming for DW15-PFE2 Goes out Cancelling or modifying a cycleLoad Button for DW15-PFE2 To select 1/2 load How to keep your dishwasher in shape Rinse-aid for DW15-PFE2 Care and maintenanceOverall condition of appliance Dishwasher salt for DW15-PFE2 Spray arms Clean both spray arms under running water With the appliance itself Fault findingResolving minor problems yourself Problems When the appliance is switched on Remnants of detergent stuck inside dispenser Lower spray arm rotates with difficultyLid in detergent compartment cannot be closed With the dishes,cutlery, etc During washing Traces of rust on cutlery Plastic items are discolouredDishes,cultlery,etc.have not been dried Glasses have a dull appearance Width 60 cm Depth Height 85 cm Capacity Technical data For Switzerland only Important informationGeneral information Page Overflow switch Heater Flowmeter Water level switch Overflow switch HeaterWiring box Way valve Door switch Softener valve