8
74Safety Precautions
In case the power cord of the water heater is
damaged, be sure to have it replaced by after service
technicians with special cord offered by the
manufacturer.
Check if the ammeter and the diameter of the wires are in
accordance with the rated current of the water heater. If
necessary please have it checked by experienced
electrician.
The water heater adopts power supply of 230V~,50Hz.
Be sure to use independent receptacle and earth it reliably.
The receptacle shall comply with the stipulation of
national standard.
The product adopts the patent ¡±"PTO 0" technology of our company. As long as adopting civil power supply, even if
the earthing wire is electrified by mistake, the "PTO 0" technology still can block the dangerous electricity, and
ensure your personal safety. But if you find perceptible current, please pull off the power plug and contact local after
service department for maintenance. Do not disassemble by yourself.

Description of the Symbols

Never do that
Be sure to act as per instructions
Set the receptacle of the water heater at dry
position away from water spraying. Do not insert
and pull the power plug with wet hands.
In winter of cold area, if the heater is idle for a long
period, please pull the handle of safety valve to discharge
the water. Otherwise it may freeze inside the water heater
and cause damages.
After installation, be sure to fill the heater completely with
water before switching on the power in the first usage.
Children must take bath under the supervision of adult.
In opening and closing the water valve, do not point
the shower head to human body. Otherwise it may
hurt by the spraying hot water.
Attentions in Installation

Safety precaution: Do not confuse the water inlet and outlet pipe. The wall

bearing the water heater shall be strong enough to endure a weight twice as
much as that of water heater filled with water.
If any part is damaged, please contact the local maintenance agent, and have it
replaced with our spare part.
Please fasten the drain hose to the drain
thread of safety valve by twisting (see to
Figure 3). Connect the other end of drain hose
to the sewer to avoid polluting the room by
splashing. When the power is switched on,
and the water heater starts operating, there
may be some water discharged from the
pressure relief hole of safety valve. It is due
to the water expansion under heating, and is
normal phenomenon. The pressure relief pipe
shall communicate with the air directly.Do not
Connect to drain hose
Installation
The water may drip from the discharge pipe of the pressure relied device
and that this pipe must be installed in a continuously downward direction
and in a frost-free environment . Check safety valve once a month as follow:
move the small handle of safety valve, if there's water flowing out, safety
valve is normal; if there's no water flow, please contact local after-sales
service station.
The pressure relief device is to be operated regularly to remove lime
deposits and to verify that it is not blocked.
block it. The discharged water can be led to the sewer.
Select suitable position on the wall to fix the shower nozzle bearer. Connect
the shower nozzle hose to the pipeline. Fasten the mixing valve. Check if
there's water leakage at each joint.
Be sure to check and confirm that the tank is filled with water, there's no
leakage at each joint and the power supply complies with the stipulation
before switching on the power.