Maintenance
1. Turn of the water and electricity supply | 2. Unplug the machine during cleaning and | ||
after every wash. Open the door to pre- | maintenance. Use a soft cloth dampened with | ||
vent the formation of moisture and odors. | soapy liquid to clean the machine case and rub- | ||
If the washing machine is left idle for a | ber components. Do not use corrosive or abra- | ||
long period, drain any remaining water in | sive chemicals or solvents. | ||
the machine and replace the drainage |
| ||
hose. |
| ||
|
|
|
|
3. Clean the detergent compartment | 4. Cleaning the Filter (once a month) | ||
regularly. For the detergent compartment |
| ||
similar to figure (a), raise the compartment | Press the lower edge of the filter compartment | ||
slightly to remove and replace after cleaning. | cover to open; | ||
|
|
| Remove the filter by turning counterclockwise; |
|
|
| (Fig3) |
|
|
| Flash clean with running water; |
|
|
| Filter replacement is the reverse of removal. Cau- |
|
|
| tion: Attention shall be paid to ensure that the fil- |
|
|
| |
|
|
| ter is replaced correctly to avoid possible leakage. |
Fig (a) | fig.1 | fig.2 | fig.3 |
|
5.To prevent block- ages to the water sup-
ply or the ingress of contaminants, clean the water inlet and in- l e t w a t e r f i l t e r regularly.
7.If the washing machine is left idle for a long period turn off the water and electricity supply and open the door slightly to prevent the formation of moisture and odors.
6.If the machine is to be moved a distance location, replace the vibration mounting locks which were re- moved during installation as shown below.
Remove the | Replace the rubber | Insert the bolts. | |
plugs. | |||
back cover. |
| ||
|
|
Tighten the bolts with the | Replace the back |
spanner provided. | cover. |
12
