Detergent and Rinse Aid

Detergent

Only detergents specifically intended for use with dishwashers must be used. The dispenser must be filled before the start of each wash cycle following the instructions provided in the "Wash Cycle Table." The detergent dispenser is located on the inside panel of the door.

Rinse Aid

This product makes dishes sparkle and helps them to dry without spotting. The dispenser is located on the inside panel of the door and should be filled after approximately 80 wash cycles (or when the rinse aid indicator light comes on for those models with this feature).

Loading the Detergent

Open the cover "A" on the dispenser, press the button "B". Then pour the detergent for the wash cycle into the compartment "C". After the detergent has been loaded, close the cover and press it down until it clicks into place.

C

B

Note : Remove excess detergent from the edges of the dispenser before closing the lid

Loading the Rinse Aid

Open the dispenser by turning the cap "C" in an anti-clockwise direction and pour in the rinse aid. ( Do not overfill ). To regulate the amount of rinse aid dispensed during each cycle, turn the dose adjuster "F", located beneath the cap, with a screwdriver. There are 6 different settings; the normal dosage setting is 3.

Important

Proper dosage of the rinse aid improves drying.

If drops of water remain on the dishes or spotting occurs, the dosage adjustor should be turned to a higher setting. If the dishes have white streaks, turn the dosage adjustor to a lower setting.

.3.