
Operating the Appliance
Starting a Wash Cycle
After completing the installation, turn on the water and press the ON / OFF button (A) located on the control panel. The indicator light "B" will come on indicating that the appliance is on, but you must wait a few seconds before programming the cycle.
Selecting a Wash Cycle
Select the desired cycle by pressing the selector button (G). Each time the button is pressed, one of the cycle indicator lights "H" will come on. Choose the wash cycle you feel is most appropriate for the type of dishes that need washing from the wash cycle chart on page seven.
Press the Start / Pause button (I), and after a few seconds a short beep will indicate that the wash cycle has begun and can no longer be changed. If necessary, read the next paragraph, "Cancelling or altering a cycle while underway..."
Cancelling or altering a cycle while underway
A cycle that is underway cannot be altered.
It must be stopped by pushing the
If you forget to load some of the dishes
To load additional dishes, push the Start/Pause button to interrupt the cycle, load the dishes then turn the appliance back on using the Start / Pause button. The cycle will continue from where it left off.
Wash Cycle Programme Light
The wash cycle is running when the cycle indicator light (H) is blinking.
At the end of the Wash Cycle
Six beeps will indicate that the wash cycle has finished and the cycle indicator light (H) will turn off. Turn the appliance off using the
Setting the Wash Cycle with a Delayed Start Time
After selecting the wash cycle as indicated in the paragraph entitled, "Setting and Starting a Wash Cycle..." the delay time can be set.
By pressing the button "E" (see
NOTE:
a) During the delay period, do not change any of the settings.
If it is necessary, all of the settings must be cancelled by pressing the
b)If the door is opened during the delay period, the indicator will blink and beep, and the countdown will stop. It will continue when the door is closed.
Wash Cycle Adjustment Buttons
1/2 Load Button
This button "C" makes it possible to wash dishes using only the upper rack when there are not enough dishes for a full load. This will save water and power. It can be used before setting any of the wash cycles, except for the intensive cycle. Please keep in mind that the amount of detergent should also be cut in half.
.5.